2000 ckp sensor location

Discuss anything related to drivetrain problems here (Engine, Transmission, etc)

Moderator: Staff

2000 ckp sensor location

Postby paul6165 » Tue Apr 27, 2021 10:16 pm

Where is ckp sensor located on 2000 Isuzu 3.2
paul6165
Drives on Pavement
 
Posts: 8
Joined: Tue Apr 27, 2021 10:40 am
Has thanked: 0 time
Have thanks: 0 time

Sponsor
 

Re: 2000 ckp sensor location

Postby Buster28 » Wed Apr 28, 2021 3:49 am

The Crankshaft Position (CKP) sensor is located on the RH side of the engine block by the motor mount attachment.
You do not have the required permissions to view the files attached to this post.
2002 Rodeo Sport 4X4 3.2L V6
2020 Jeep Wrangler 2dr 4x4 3.6L V6
User avatar
Buster28
4L30E Guru
 
Posts: 11509
Joined: Fri Dec 18, 2009 12:28 pm
Location: RI
Has thanked: 10 times
Have thanks: 1308 times

Re: 2000 ckp sensor location

Postby paul6165 » Wed Apr 28, 2021 9:00 am

Thanks to everyone for the help this forum is a life saver more info than I would have found any where else. I will keep you advised on what I find to help others.
paul6165
Drives on Pavement
 
Posts: 8
Joined: Tue Apr 27, 2021 10:40 am
Has thanked: 0 time
Have thanks: 0 time

Re: 2000 ckp sensor location

Postby paul6165 » Wed Apr 28, 2021 1:51 pm

Ok removed sensor I am getting 4.9 volt on two wires that doesn't seem correct. The two outside wires looking for wiring dia for crank sensor may be shorted between 2 wires.
paul6165
Drives on Pavement
 
Posts: 8
Joined: Tue Apr 27, 2021 10:40 am
Has thanked: 0 time
Have thanks: 0 time

Re: 2000 ckp sensor location

Postby paul6165 » Wed Apr 28, 2021 8:38 pm

Back to basics 1 wire power 1 ground 1 pulse signal all connected to computer. If I didn't get timing correct I should still get a pulse from crank sensor. This is puzzling the truck was running ok just heat problem so leads me to believe computer and sender are ok. Next step I am going to get some gas in spray bottle spray into intake while cranking see if starts.
paul6165
Drives on Pavement
 
Posts: 8
Joined: Tue Apr 27, 2021 10:40 am
Has thanked: 0 time
Have thanks: 0 time


Who is online

Users browsing this forum: Google [Bot], Google Adsense [Bot] and 27 guests