Isuzu SUV Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
7,528 Posts
Discussion Starter · #1 ·
looking for a cap for my 89 spacecab. can be cab high or have the bump up in the FRONT and then same height back. i DO NOT want the one that kicks up in the back about 1/2 way back and is 9 feet high. Cab high preferred. long windows on side, none of the double ovals or anything like that. Windowless is OK, but prefer to be able to see out the sides :)

does anyone know what other models (Nissan, toyota) fit the isuzu beds??? years??

will travel the east coast (to NC) for the right cap and price.....

thanks
Ron
 

·
Registered
Joined
·
1,938 Posts
lowzone said:
does anyone know what other models (Nissan, toyota) fit the isuzu beds??? years??
thanks
Ron
Hey Ron, about the only thing that comes close as far as measurements go are the '94-2002 Chevy spacecab's. The bed tappers off from 62" to 60" at the rear... all the early Rangers, Nissan and Toyota's have a different bed length by a couple of inches either in width or length.

A lot of it depends on the manufacture itself, you might find a slight overhang of the cab by about 1" on each side for the Chevys.

Are you looking for something like these?
http://greenville.craigslist.org/pts/2468471125.html

http://columbia.craigslist.org/pts/2466564926.html
 

·
Registered
Joined
·
7,528 Posts
Discussion Starter · #3 ·
Van,
thanks for the info. the 1st link is what im looking for or even windowless shell would work. i just picked up a 04 Ram 1500 shortbed cover im going to cut and modify to fit for the one truck, but the spacecab id like shell/cap

Ron
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top