Isuzu SUV Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
Hey guys,

Just did one side of my front wheel bearings (passenger) but noticed a part of the "how to" on wheel bearings I hadn't read before. It said to put in a gasket between the nub cap and the hub flange (parts 1 and 40 in the link below). I see it listed in the isuzu diagram but didn't know I needed it. Dave mentioned using gasket maker instead of the actual gasket. How/where would you place the line of gasket goo?

I'm thinking of circling all of the holes where the allen keys go and a large circle just inside the allen key holes. Thoughts?
 
1 - 1 of 1 Posts
Top