Isuzu SUV Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
822 Posts
at my work there are a bunch of spark plug sockets that have been turned in the lathe , to make their diameter smaller...

you could always tack weld the extension to the socket...or wrap tape around the joint where the socket and extension meet...

and yes, remove the rubber insert....if you are careful you wont break the spark plug...and getting that rubber insert off the plug, once the plug is in the hole, is a pain in the ***....and the rubber hose is a great removal / install trick...esp on install, the hose should slip if the plug cross-threads, saving you a heli-coil job :evil:
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top