Isuzu SUV Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
5,980 Posts
Discussion Starter · #1 ·
I have barely anytime to look for parts with work this summer so if you guys come across any of these things or have them on hand can you please let me know?

Front Drive shaft from a 99 Manual Trans Amigo or Rodeo 4x4
Silver Fender and Door for the Driver side from a 98+ Rodeo or Amigo
Shift boots and center console from a 5 spd 98+ Rodeo or Amigo 4x4

Thanks
8)
 

·
Registered
Joined
·
1,091 Posts
I have the center console with no boot tho.....

if you want it...make me an offer.....

keep my eyes open for the rest
 

·
Registered
Joined
·
6,257 Posts
I believe the drive shaft of the autos and manuals are the same. If that is the case I have one for ya.
 

·
Registered
Joined
·
1,091 Posts
i had to have my drive shafts cut and lengthened when i did my conversion.... i think the rear was lengthened and the front was cut if i remember correctly.....theres a place here in Cranberry that did a great job with it..!!!!

if i remember correctly the transmission on the 5spd is shorter and lighter to the rear end....it was a couple years since i did it but im pretty sure thats whats up...
 

·
Registered
Joined
·
5,980 Posts
Discussion Starter · #6 ·
Ya I have a driveshaft for the rear I just need one for the front so it has 4wd again :D. If I cannot find one before I get home in August I will just get it shortened.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top