Isuzu SUV Forum banner
1 - 11 of 11 Posts

·
Registered
Joined
·
1,796 Posts
i like it!! but the departure angle is a biatch
 

·
Registered
Joined
·
793 Posts
just too heavy for 4L30E to push this much parties!
 

·
Registered
Joined
·
6,859 Posts
Selador said:
Cronk said:
That's kinda cool!

It might make a cool RV conversion.
That's what I was thinking.
Covert to 5 speed. Put a VW pop up on it, couple of captain's chairs, small kitchenette, full size mattress in back.................. :lol: :lol:

Ron, you need this!
 

·
Registered
Joined
·
7,538 Posts
Discussion Starter · #8 ·
ok stupid question BUT would a 4L60e fit the motor? its a better trans they use in the Blazers and fullsize trucks (with the 4.3L or 5.0L)....then go up to the 4L80 on the big blocks....but is it the same bellhousing design???????????
 

·
Registered
Joined
·
4,646 Posts
lowzone said:
ok stupid question BUT would a 4L60e fit the motor? its a better trans they use in the Blazers and fullsize trucks (with the 4.3L or 5.0L)....then go up to the 4L80 on the big blocks....but is it the same bellhousing design???????????
I don't think you can swap the bell housings between 4L30's and 60's (I don't think you can, but maybe you can) but I don't know about transfer case location or any of that crap. so uh to answer your question... hell no. :lol:
 

·
Registered
Joined
·
8,605 Posts
no you can't swap the housings, your closest bet is the 700r4 from an S10
 

·
Registered
Joined
·
116 Posts
That thing is crazy!!! The posting is expired though, did someone buy it?! LOL!
 
1 - 11 of 11 Posts
Top