Isuzu SUV Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
745 Posts
Discussion Starter · #1 ·
Just a brief update and some pics. Took a bit over an hour. Instead of tapping off one of my 12V outlets, I just killed one of them, and connected the CB to the existing wiring...I only ever use one anyways. Lost the hanger for the mic, though :(



 

·
Registered
Joined
·
2,707 Posts
Nice! Mic clips are cheap like super sized fries, it just means you get to post another pic when you mount the new one! LoL

~psguardian
 

·
Registered
Joined
·
677 Posts
With the antenna mount bolted to the tail gate, what happens when you want to open the gate or did you leave a coil of coax inside the truck?
 

·
Registered
Joined
·
4,646 Posts
johnnie59 said:
With the antenna mount bolted to the tail gate, what happens when you want to open the gate or did you leave a coil of coax inside the truck?
98+ swing sideways, but i imagine he still needed a little slack.
 

·
Registered
Joined
·
745 Posts
Discussion Starter · #7 ·
the stock cable (10ft) wasn't long enough, had to spend a few bucks for a 20ft: plenty of slack. Ran it between the support bar and rear window, into the trim where the roll-bar meets the marine box (where seat belt comes through paneling). Then I just guided it to the driver seat, across the console, and back under the trim behind the radio.
 

·
Registered
Joined
·
4,646 Posts
johnnie59 said:
Yeah.. I knew that... duh. Old man itis is eating away at my brains...
can't use that excuse... im not even old enough to vote :laughing6:
 
1 - 9 of 9 Posts
Top