Isuzu SUV Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
408 Posts
Discussion Starter · #1 ·
I am thinking of building a small bustle rack (old 19E's rise) on the tail gate of the Amigo out of aluminum bar stock. This will be on the inside of the gate. So which attachment method would prove better for this sheet metal screws or pop rivets? The rack will not be used to haul serious weight, just a place to stow gear stuff junk.
 

·
Registered
Joined
·
555 Posts
Sabre07 said:
I am thinking of building a small bustle rack (old 19E's rise) on the tail gate of the Amigo out of aluminum bar stock. This will be on the inside of the gate. So which attachment method would prove better for this sheet metal screws or pop rivets? The rack will not be used to haul serious weight, just a place to stow gear stuff junk.
I might go with small bolts with washers to spread the force.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top