Isuzu SUV Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
297 Posts
Discussion Starter · #1 ·
Can any one tell me if it would be bad or how it would effect things or handle differently if I had radial tires on my front axle and bias belted tires on my rear axle?

So I have 4 LT265/70R16 Super Swamper SSRs but the front two have severe camber wear because I have been having a very hard time keeping the alignment correct.

So I'm looking at just getting two new tires and I'm really liking the Super Swamper SX and the 32x11.50-16LT are the same exact outer diameter and slightly wider but they are bias belted instead of the radials I have.

Also wondering if it would look bad or dumb having SSRs in the front and SXs in the rear.
 

·
Registered
Joined
·
135 Posts
You can not mix bias ply and radial tires at all, very bad handling would result.
 

·
Registered
Joined
·
8,073 Posts
Yep, bad idea on the road. They have very different characteristics in cornering and you are quite likely to spin out with that setup.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top