Isuzu SUV Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
57 Posts
I'm installing a new remote start/alarm system in my 98 Isuzu Passport … I'm having a hard time with it though. I can't find a good door trigger wire (dome light wire) the one I found in the driver's side kick panel (red wire with green stripe) only shows a positive 12 volt signal when the door is closed and the dome light switch is in the middle setting. When the door is open it goes to 2 volts.
That is the main thing I'm hung up on. I have not been able to find a good diagram of the wiring with descriptions on how to find all the wiring for the keyless entry and factory alarm.
Should I completely cut out the factory alarm or integrate it with my new system.
The system I'm installing is an Avital 5303.
Any insight would be helpful , thanks
 

·
Registered
Joined
·
57 Posts
Thanks, that helps. Do you think it will be a problem that it is going to 2VDC instead of 0VDC?
 
1 - 2 of 2 Posts
Top