Isuzu SUV Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
hey guys,
I am from Australia, and i drive an isuzu mu.

Unfortunately I am having trouble with the wiring on my swap.

My car is a 1992 isuzu mu, 4jb1t powered :blackeye:

The gear box I am using is the MUA5, its mounted but i dont have a wiring harness for it.
So what wires do i have to connect to get this bloody car started?

any help would be greatly appreciated, ive already had a read of all the transmission swaps i can find on this site.
i will update this with pictures in a little while, cheers
 

·
Super Moderator
Joined
·
2,670 Posts
Hello,
I really don't know much about trans swaps but since nobody has answered I will...
The MUA5 shouldn't have anything to do with the vehicle running or not. You should only have a reverse light switch and(if it's 4x4) a 4wd indicator switch. What you may have is some problem with the remaining wiring from the old trans... But anyhow that probably doesn't help you much...
 

·
Registered
Joined
·
1 Posts
hey guys,
I am from Australia, and i drive an isuzu mu.

Unfortunately I am having trouble with the wiring on my swap.

My car is a 1992 isuzu mu, 4jb1t powered :blackeye:

The gear box I am using is the MUA5, its mounted but i dont have a wiring harness for it.
So what wires do i have to connect to get this bloody car started?

any help would be greatly appreciated, ive already had a read of all the transmission swaps i can find on this site.
i will update this with pictures in a little while, cheers
Howdy, Dan here, I know this a long time ago, however the auto in your Isuzu MU what was it? I hope to get hold of one of these for 4 X4 conversion, Dan
 
1 - 4 of 4 Posts
Top