[Que_Honda!]

I'm working on replacing the intake manifold gaskets, and all the other junk under there while I'm at it, but I can't figure out how to remove the wiring harness connector from the fuel injectors?

Do I pull the blue piece, and then push in and yank on it? Not sure on the process.

 

[JLEMOND]

I'm working on replacing the intake manifold gaskets, and all the other junk under there while I'm at it, but I can't figure out how to remove the wiring harness connector from the fuel injectors?

Do I pull the blue piece, and then push in and yank on it? Not sure on the process.

UN LOCK THE AND REMOVE THE LITTLE BLUE PIECE AND THEN PRESS THE LOCK O THE INJ AND GENTLY PULL THE WIRE , DONT PULL IT OUT BY YANKING ON IT , THYE ARE FRAGILE LITTLE CONNECTORS, AND BE CARE FULL PUTTING THEM BACK IN , IT IS EASY TO BEND THE SMALL PINS,

 

[Que_Honda!]

Thanks for the help. I didn't actually mean I would yank on it, bad use of the word on my part.

Thanks again.

 

[JLEMOND]

Thanks for the help. I didn't actually mean I would yank on it, bad use of the word on my part.

Thanks again.

I KINDA FIGURED THAT, THEY ARE SO SMALL IF YOU DID GIVE THEM A HARD JERK YOU WOULD PROB, PULL THE INJ APART.