Isuzu SUV Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter · #1 ·
Hi I looked high and ow for the answer to this but can't seem to find it. If someone can help it would be greatly appreciated. I have a 1992 trooper 3.2 DOHC I wanna pull the codes from it but can't seem to find the ALDL connector to jump the pins??? looked under the steering will found some connectors but not a 3 pin connector like they say in the isuzu dealer shop manual they say in the book it's a white 3 pin connector and to jump 1 to 3 and voila lol but they fail to mention where it's located lol Does anybody have a cluie or a picture to show me what it exactly look like ? :)

thanks a bunch

Jay
 

·
Registered
Joined
·
8,073 Posts
Should be somewhere under the center of the dash, might have to take the trim off the console to see it.
 

·
Registered
Joined
·
25 Posts
Discussion Starter · #3 ·
Center of the dash as in by the ash tray heat vent area's ? may you think?
 

·
Registered
Joined
·
8,073 Posts
Yeah, on the "floor" under the center of the dash. On my 93 it was basically right by my right foot behind the trim.
 

·
Registered
Joined
·
25 Posts
Discussion Starter · #5 ·
cool man thanks again for the help much thanks again I'll look there don't see them moving it around that much from 1992 to 1993 :p I'll let ya know if I find it :p
 
1 - 5 of 5 Posts
Top