Isuzu SUV Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-10 of 10 Results
  1. Drivetrain Problems
    Hi planet, '96 Rodeo 3.2L V6, MUA5 5-speed I'm desperately trying to finish up a rear main oil seal install. I replaced the clutch too, while I was back there. Now I've got the transmission back in place, but for the life of me, I cannot get the clutch slave cylinder back in place. It can't be...
  2. General Isuzu Discussion
    Hello, my Clutch and Brake Master cylinder leaks a little bit of fluid through the floorboards Every time the clutch pedal is pushed. A seal is broken on the part. I was wondering where i could get a part for this. I am in Nashville Tennessee and the Bighorn is from Japan. If a rebuild would be...
  3. Drivetrain Problems
    Feel kinda stupid making this post as I assume it's just the pressure plate going, but I figured I could just get a second opinion on it so here it goes. I'm running an 86' trooper and somewhat recently, the clutch will momentarily pause about 2 or so inches from the top after fully depressing...
  4. Classifieds
    Hi All, I bought this clutch kit for my MUA5, only to find out that it was wrong (thanks to rockauto listing the wrong part number). Its been too long since I ordered it to return it, so its for sale. It includes: Pressure plate Friction disk Throwout Bearing Pilot Bearing Spline Alignment...
    $100 USD
  5. Drivetrain Problems
    So, I’ve replaced my clutch, flywheel, pressure plate, throw out bearing with a FX Racing brand. I’ve had this trans on the ground 4 times because the TOB keeps popping out. Everything goes back together fine, tob pops in, you can press the hell out of the clutch pedal and it won’t back out, but...
  6. Drivetrain Problems
    So, the story goes I blew up my ’89 trooper’s 4ZE1, so I pulled the engine from my ‘90 Pickup to drop in until I get my real swap ready to drop in. I know most of the little differences between the ‘89 and the ‘90, and have all the electrical and the distributor swapped, but what’s catching me...
  7. Drivetrain Problems
    So the other day I was driving and my clutch started to act like it didnt want to spring back, with alot of shaking feedback in the pedal. 246,000 miles, It looks like the throw out bearing popped out of the lock collar. Ill be replacing the whole 9 yards (clutch, pressure plate, flywheel etc)...
  8. General Isuzu Discussion
    Hi All, My original clutch slave cylinder was leaking so I replaced it. Well, the new one leaks as well through a seal around the plunger, fluid is coming out of the bellow dust seal. I doubt I did something wrong but open to advice. I've never had an issue with replacing clutches before...
  9. Drivetrain Problems
    Any guesses as to why the manual transmission would be noisy in neutral, 1st, 2nd, 3rd, and 5th? It only sounds normal with the clutch pedal engaged, or in 4th gear. Shifts fine. Drives fine. I thought it was an internal bearing of some sort, but it's become more prominent and obvious where...
  10. Drivetrain Problems
    I am looking for a line for my clutch on my 91 trooper 2.8 v6, 5 sp 4x4 tbi. It goes to the slave cylinder and has a banjo connector on one end and a nut on the other (connects to a box on the drivers wheel well in pic... not the master cylinder). The line I need is about 61 inches long and...
1-10 of 10 Results
Top