Isuzu SUV Forum banner

rear disc brake caliper bracket bolt size? !

2K views 13 replies 2 participants last post by  Buster28 
#1 ·
00RODEO4wd 3.2

Does anyone know the part no(s) of the 17mm caliper bolt that holds the caliper bracket ?!

(after a brake job, one came off ; luckily noticed before it grinded the rim too much.
 
#4 ·
Sh_YVR said:
thanks buster...
any suggestions on an e-store ? kinda hard to figure out who actually keeps it.. I'm close to MN.grandforks..
I also may try the HONDA dealer here..
The caliper bolt was used from 1994 to 2002 with Honda and Acura so a local dealer may have one in stock.
The parts stores and amazon sell caliper hardware kits that include these bolts and the pins, the trick is to find the correct ones for your truck. It is 12mm x 27mm and I think the pitch is 1.25mm
 
#11 ·
I have used a 4ft piece of pipe on a breaker bar to get them loose so the bolts are industrial strength quality.
They don't need to be very tight, just a little blue thread locker to keep them tight.
 
#12 ·
Btw. are you aware that the two caliper slide pins/bolts are not the same. The top one is the Guide bolt and the bottom one is the Lock bolt.
The Guide Bolt has two flats and the head has the letter G stamped on it.
The Lock Bolt is round.
Torque: 44 N·m (32 lb ft)
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top